Router Table: Difference between revisions
From London Hackspace Wiki
Deanforbes (talk | contribs) (could not find in search the article "Milton discussed this on the list") |
(Page Creation) |
||
| Line 3: | Line 3: | ||
|image=Hackspace_Unknown.png | |image=Hackspace_Unknown.png | ||
|category=Equipment | |category=Equipment | ||
|subcat=Woodworking | |||
|status=Good working order | |status=Good working order | ||
|reqtraining=no | |reqtraining=no | ||
|acnode=no | |acnode=no | ||
|origin=Built in Space | |||
|origin= | |||
|location=Woodshop | |location=Woodshop | ||
|maintainers= | |maintainers=Aidas Baltusis, Jonathan Hodgson | ||
}} | }} | ||
a | A router table useful for a variety of shaping and profiling tasks in wood. | ||
The table was constructed by Hackspace members using several commercially available key components, including | |||
* Router: Triton, part no unknown | |||
* Insert plate: Rockler, part no unknown | |||
* Fence Rockler, part no unknown | |||
* Mitre guide, part no unknown | |||
The router has a 1/2" collet and should ideally be used with 1/2" cutters. A reducing bush (soon to be replaced by dedicated 1/4" collet) are available which can be used to hold 1/4" cutters, although lighter cuts must be taken | |||
A range of additional jigs e.g. a box joint jig are available | |||
Revision as of 10:06, 6 May 2022
| Router_Table | |
|---|---|
 | |
| Sub-category | Woodworking |
| Status | Good working order |
| Last updated | 6 September 2024 08:24:04 |
| Training requirement | no |
| ACnode | no |
| Origin | Built in Space |
| Location | Woodshop |
| Maintainers | Aidas Baltusis, Jonathan Hodgson |
A router table useful for a variety of shaping and profiling tasks in wood.
The table was constructed by Hackspace members using several commercially available key components, including
- Router: Triton, part no unknown
- Insert plate: Rockler, part no unknown
- Fence Rockler, part no unknown
- Mitre guide, part no unknown
The router has a 1/2" collet and should ideally be used with 1/2" cutters. A reducing bush (soon to be replaced by dedicated 1/4" collet) are available which can be used to hold 1/4" cutters, although lighter cuts must be taken
A range of additional jigs e.g. a box joint jig are available
