Pledge: Lathe Milling Machine Combo Tools: Difference between revisions
| Line 31: | Line 31: | ||
* Adapters for existing tooling: Rough estimate of £10 per adapter? | * Adapters for existing tooling: Rough estimate of £10 per adapter? | ||
** What adapters are required ? | ** What adapters are required ? | ||
** I'm thinking things like MT2/MT3 sleeves or whatever is required to make minimill cutters fit the 3-in-1 | |||
* angle plate, for things that aren't completely made of right angles | * angle plate, for things that aren't completely made of right angles | ||
* vertical rotary table, for gears and other fun things (can we use the existing one vertically?) | * vertical rotary table, for gears and other fun things (can we use the existing one vertically?) | ||
Revision as of 13:14, 12 April 2011
The Problem
A super new 3-in-1 is installed at the Hackspace. It comes with a basic set of tooling:
- 125mm 3-Jaw Chuck
- 1-13mm Drill Chuck & Arbor
- MT4 & MT3 Steel centres
- Lathe Tool Set
- Milling Drawbar
- 4-Way Indexing Toolpost
- Combined Vice/Compound Slide
- Lathe & Drill Chuck Guards
We will, however, require many more toys serious tools in order to create our projects.
Note that it is traditional to make some of the tooling. It isn't efficient in terms of time (there are many sources of cheap chinese-made tooling which, although sometimes dreadful, can often be better finished than home-made) but it's enormously valuable in teaching how to use the tooling, machining techniques etc.
Good candidates for home-made tooling are:
- More vices (especially wide-opening ones)
- Stub arbors (things that hold a simple cutter in the mill instead of a chuck)
The Hardware
We need :
- fly cutter, for making nice smooth surfaces (already exists?)
- t-slot cutter, for making work-holding surfaces
- bigger drill bits, to start bore holes
- a block for raising work to be milled (absolutely required)
an independent 4-jaw chuck: 4-jaw chuck(Ordered by Russ, £90.53)- Adapters for existing tooling: Rough estimate of £10 per adapter?
- What adapters are required ?
- I'm thinking things like MT2/MT3 sleeves or whatever is required to make minimill cutters fit the 3-in-1
- angle plate, for things that aren't completely made of right angles
- vertical rotary table, for gears and other fun things (can we use the existing one vertically?)
Other items will be added to this list over time. If you want to add an item, please check first if there is an existing tool that could be used via the adapters.
Pledges
Please indicate next to your pledge, if you would rather contribute to a single item, otherwise your contribution will be spread across the list of all items.
Running Total: £220
Target: Over £9000
