Difference between revisions of "Meddings Pillar Drill"
(Image Added) |
(Risk Assessment Added) |
||
| Line 18: | Line 18: | ||
Generally for use on metal only, there are other pillar drills available in the woodshop for use on wood. An exception might be granted for extremely large holes where the extra power is required, but if this is done then sawdust must be throughly removed from this drill and all surrounding machines (TIG bench and donkey saw) | Generally for use on metal only, there are other pillar drills available in the woodshop for use on wood. An exception might be granted for extremely large holes where the extra power is required, but if this is done then sawdust must be throughly removed from this drill and all surrounding machines (TIG bench and donkey saw) | ||
| + | |||
| + | {{:Risk Assessment/ Pillar Drills}} | ||
Revision as of 21:04, 13 August 2024
| Pillar Drill (Meddings) | |
|---|---|
 | |
| Model | uF5/FS |
| Sub-category | Metalworking |
| Status | Good working order |
| Last updated | 5 September 2024 12:52:23 |
| Training requirement | no |
| ACnode | no |
| Location | Metalworking shop |
| Maintainers | Metalshop team |
A large floorstanding pillar drill with quite impressive drilling capcity
No training requirement, but please seek advice from other metalshop users if you are unfamiliar with its use
Always remove drill bits from the chuck and sweep away swarf after use
Generally for use on metal only, there are other pillar drills available in the woodshop for use on wood. An exception might be granted for extremely large holes where the extra power is required, but if this is done then sawdust must be throughly removed from this drill and all surrounding machines (TIG bench and donkey saw)
Risk Assessment - Pillar Drills
This risk assessment is intended to provide guidance on the risk associated with the above equipment and activities in normal use. Please also check general risk assessments for the space as a whole. Any discrepancies, errors or concerns should be raised with the document maintainers or trustees - do not edit this assessment directly. For responsible persons and last update, see 'version log' of the assessment page.
Activity
Cutting metal or suitable plastics on the metal mill
Signage
Understanding Risk Rating
LOW - Ensure current control measures are in place and continue with activity
MED - Control measures may be adequate, co-supervision is recommended
HIGH - Do not undertake activity without further consultation with area specialists
Risk Assessment
| Identify Hazards | Who May be Harmed and How | Severity | Control Measures | Likelihood | Risk Rating |
|---|---|---|---|---|---|
| Incompetent user | User, Bystander | HIGH | Users must not use tools that they are not competent to use. Members must challenge use that they believe is dangerous. Users must read the user manual where applicable. Users must read the risk assessment before using a tool. | LOW | MED |
| Contact With Drill Bit | User – serious harm | HIGH | Only make adjustments to the pillar drill when the machine is switched off. Ensure chuck is tight before switching drill on. Ensure drill guard is in place before switching drill on. Do not put hands into exclusion zone (within 10cm of drill bit). Do not leave pillar drill running when not in use. | LOW | MED |