Difference between revisions of "Denford CNC 2600"
Jump to navigation
Jump to search
Deanforbes (talk | contribs) |
|||
Line 27: | Line 27: | ||
===== Next steps ===== | ===== Next steps ===== | ||
*mcodes test | *mcodes test | ||
+ | ** sample output from obsolete software | ||
*tool change | *tool change | ||
+ | ** add links to correct use of ER20 collets | ||
*gcode generation | *gcode generation | ||
+ | ** gcode editors | ||
+ | ** CAM tools | ||
*fixturing | *fixturing | ||
+ | ** Underlying aluminium t-slot table | ||
+ | ** as-delivered sacrificial table | ||
+ | ** replacement bolt-down table | ||
*cut something | *cut something | ||
+ | ** dust extraction | ||
+ | There is a hole at the top rear left of the cabinet which may be used for dust extraction - either a separate unit or a connection to the shop extractor. However, the cutting dust tends to lie around the cutter so some means to move it to the extraction is required. Possibilities are throwing it into the air and then extracting the air, or sucking directly at the cutting tip. There is a small air pump in the cabinet whose output is taken to a connector under the gantry parking position. This may be used to disturb the air near the cutter, and a flexible hose to the extraction used to remove it. The hoses needed may get in the way : this requires some experiment. | ||
*AC Node | *AC Node | ||
*Training and inductions | *Training and inductions |
Revision as of 13:50, 5 February 2022
Denford CNC | |
---|---|
![]() | |
Model | 2600 pro |
Sub-category | CNC |
Status | View tool status |
Last updated | 17 September 2022 12:50:55 |
Training requirement | yes |
Training link | cnc_denford_2600_training |
ACnode | not yet |
Owner | LHS |
Origin | Donation |
Location | Ground Floor, Woodshop |
Maintainers | Kunal Claude Steve Dean |
Progress Update 22/09/21 KP
- Win 10 PC setup
- VR CNC Mill v5 installed
- 2D CAM Pro installed
- Machine jogs-OK
- home cycle-OK
- spindle runs-OK
Next steps
- mcodes test
- sample output from obsolete software
- tool change
- add links to correct use of ER20 collets
- gcode generation
- gcode editors
- CAM tools
- fixturing
- Underlying aluminium t-slot table
- as-delivered sacrificial table
- replacement bolt-down table
- cut something
- dust extraction
There is a hole at the top rear left of the cabinet which may be used for dust extraction - either a separate unit or a connection to the shop extractor. However, the cutting dust tends to lie around the cutter so some means to move it to the extraction is required. Possibilities are throwing it into the air and then extracting the air, or sucking directly at the cutting tip. There is a small air pump in the cabinet whose output is taken to a connector under the gantry parking position. This may be used to disturb the air near the cutter, and a flexible hose to the extraction used to remove it. The hoses needed may get in the way : this requires some experiment.
- AC Node
- Training and inductions
Schematics
- File:MRP-0850 ESTOP relay contacts.pdf
- Schematic design B (Note we have version A so there maybe some differences) File:Schematic Design MRP-0850B.pdf
Manuals
- User Manual File:Router 2600 Pro Operator Manual.pdf
- VR CNC Control Software v5 Training Guide File:VR Milling 5.pdf