Denford CNC 2600

Denford CNC
Model	2600 pro
Sub-category	CNC
Status	View tool status
Last updated	19 August 2024 07:32:52
Training requirement	yes
Training link	cnc_denford_2600_training
ACnode	not yet
Owner	LHS
Origin	Donation
Location	Ground Floor, Woodshop
Maintainers	Kunal Claude Steve Dean

Next steps

• Install MESA
• Configure Linuxcnc

• • dust extraction

There is a hole at the top rear left of the cabinet which may be used for dust extraction - either a separate unit or a connection to the shop extractor. However, the cutting dust tends to lie around the cutter so some means to move it to the extraction is required. Possibilities are throwing it into the air and then extracting the air, or sucking directly at the cutting tip. There is a small air pump in the cabinet whose output is taken to a connector under the gantry parking position. This may be used to disturb the air near the cutter, and a flexible hose to the extraction used to remove it. The hoses needed may get in the way : this requires some experiment. A dust shoe may be helpful but will hide the cutting point from view.

• Prepare Inductions
• AC Node

Collets

• We are using ER 20 collets
• You will need to provide your own tooling
• Use of collets ER Collet Essentials. https://www.youtube.com/watch?v=WKikm6cQKh0

Training and induction s

TBD

Materials

• This is in the woodshop and to be used on non metal materials only.
• No liquid or mist coolant is to be used in the machine at all.

Schematics

• 
• File:MRP-0850 ESTOP relay contacts.pdf
• Schematic design B (Note we have version A so there maybe some differences) File:Schematic Design MRP-0850B.pdf
• Cabinet Wiring

Manuals

• User Manual File:Router 2600 Pro Operator Manual.pdf
• VR CNC Control Software v5 Training Guide File:VR Milling 5.pdf
• Spindle VFD File:Baldor-VS1ST-Micro-Series-Manual.pdf
• Stepper drive File:MSD556-V2.0 stepper-drive-datasheet-v3.0.pdf
• Some notes on the Baldor Nextmove controller originally fitted [1]
• Manual for the original Nextmove ST controller [[]]
  • this has an additional top board which adds DSP movement control and replaces the built-in stepper drives with external drives

MESA 7i76

• 7i76e Manual File:7i76eman.pdf
• 7i76e Connection Guide File:7i76 Con Guide.pdf
• 7i76e Mounting Base File:7i76E mounting base 2.pdf

Plate 262x140
Cabinet mounting holes for this base are 132x212, 20 from LHS and 30 from RHS
Mesa board to be at LHS

Linuxcnc

TBD - GITHUB Repository