53
edits
Equipment/DrillPress: Difference between revisions
From London Hackspace Wiki
m
→Log
m (→Status) |
m (→Log) |
||
| Line 57: | Line 57: | ||
#<artag> if there's a screw thread in the end of the taper thrn it can use a drawbar like the 3-in-1 but that's fairly unlikely | #<artag> if there's a screw thread in the end of the taper thrn it can use a drawbar like the 3-in-1 but that's fairly unlikely | ||
#<lovelace_> K, seems firmly in now | #<lovelace_> K, seems firmly in now | ||
#9 Aug 2013 - sjrapid and will took the arbour and chuck off, and tested the quill run out with a dial indicator. Also tested with a new certified chuck and arbour (0.0012 TIR). Measured run out of about 0.25mm on the new chuck. TIR not measured on the existing keyless chuck. | |||
