53
edits
Equipment/DrillPress: Difference between revisions
From London Hackspace Wiki
no edit summary
m (→Log) |
No edit summary |
||
| Line 5: | Line 5: | ||
|category=Equipment <!-- Main category. Please leave alone to keep item in this category --> | |category=Equipment <!-- Main category. Please leave alone to keep item in this category --> | ||
|subcat=Fabrication <!-- Sub-category if one exists. Please check main listing to see other categories contained within the main one --> | |subcat=Fabrication <!-- Sub-category if one exists. Please check main listing to see other categories contained within the main one --> | ||
|status= | |status=Working order<!-- Set to one of; Good working order, Faulty, Out of order, Under construction, Out of consumables, Scrapped, or Unknown --> | ||
|consumables=oil, cutting fluid,drive belt<!-- Any items used up in normal operation, such as; ink, paper, saw-blades, cutting disks, oil, etc.. --> | |consumables=oil, cutting fluid,drive belt<!-- Any items used up in normal operation, such as; ink, paper, saw-blades, cutting disks, oil, etc.. --> | ||
|accessories=Unknown <!-- Any items associated with the equipment but not consumable, such as; drill bits, safety gloves, goggles, etc.. --> | |accessories=Unknown <!-- Any items associated with the equipment but not consumable, such as; drill bits, safety gloves, goggles, etc.. --> | ||
| Line 18: | Line 18: | ||
}} | }} | ||
==Status== | ==Status== | ||
'''Works, but is not very precise!''' | |||
Quill run out is approximately 0.010mm - should be <0.002mm. Chuck runout is anything up to 10x this. Your holes may be oval! | Quill run out is approximately 0.010mm - should be <0.002mm. Chuck runout is anything up to 10x this. Your holes may be oval! | ||
