Equipment/DrillPress
From London Hackspace Wiki
| Drill press | |
|---|---|
 | |
| Model | Axminster ED16SB |
| Sub-category | defunt |
| Status | Disposed of |
| Consumables | oil, cutting fluid,drive belt |
| Accessories | Unknown |
| Training requirement | No |
| Training link | Unknown |
| ACnode | No |
| Owner | LHS |
| Origin | Unknown |
| Location | Woodshop |
| Maintainers | sjrapid |
Status
Works, but is not very precise!
9 Aug 2013 - sjrapid and will took the arbour and chuck off, and tested the quill run out with a dial indicator.
Quill runout is approximately 0.2mm (should be <=0.02mm, 1thou) ). Runout at the chuck can be anything up to 10x this depending on selected speed and cutting bit. Your holes may be oval!
Here's the dial-indicator test video:
There is a pledge running to get a new Drill Press for the space.
The space has an Axminster drill press. The keyless chuck only goes down to 2.7 mm, so for anything smaller you need a "pin chuck".
Or you can use the Dremel and mini-mill for high speed / light duty / precision stuff. Ideal jobs :
Dremel
- High speed, tiny bits e.g. PCB drilling
Mini-Mill
- Milling plastic, small aluminium etc.
- Drilling jobs requiring accurate positioning - use the table positioning
Drill Press
- Most general purpose drilling jobs
Model
- Make: Axminster
- Model: ED16SB
- Manual: on the Axminster website
Pictures
Log
- <lovelace_> The chuck for the new stand drill falls out easily
- <lovelace_> I can't see how it tightens up
- <artag> it should be a taper. Assuming it's clean (not got anticorrosion varnish on it) then it should want a good fast whack up into the quill. Not with a hammer - just push it fast, by hand. Use the momentmum of the chuck to get it in hard.
- <artag> if there's a screw thread in the end of the taper thrn it can use a drawbar like the 3-in-1 but that's fairly unlikely
- <lovelace_> K, seems firmly in now
- 9 Aug 2013 - sjrapid and will took the arbour and chuck off, and tested the quill run out under no load with a dial indicator. Also tested with a new certified chuck and arbour (0.0012 TIR). Measured run out of about 0.25mm on the new chuck. TIR not measured on the existing keyless chuck.
