Difference between revisions of "Equipment/Lathe"
(→Status) |
(→Status) |
||
| Line 13: | Line 13: | ||
=== Status === | === Status === | ||
| − | <code>?minilathe</code> Not working yet: | + | <code>?minilathe</code> Not working yet: Brushes replaced, motor spins but far too slowly, '''need someone''' who knows control electronics to take a look |
=== Updates === | === Updates === | ||
Revision as of 01:09, 10 October 2012
Mini Lathe
http://wiki.london.hackspace.org.uk/view/Lathe_Training
Possible motor controller info (needs confirmation that it's relevant)
The mini-lathe is an example of a widely copied 7x12 lathe that has been manufactured in several versions
See also Equipment/LatheMillCombo for the bigger mill / lathe
Status
?minilathe Not working yet: Brushes replaced, motor spins but far too slowly, need someone who knows control electronics to take a look
Updates
Update 02/10/2012
mentar: Coils fine, commutator covered in a beefy layer of carbon, one brush almost gone. Replaced the brush with a smaller one from a one of the motors in the "motors" box, cleaned the carbon residue off the commutator and it works, sort off. The speed controller only works for a small range and the speed is constant after about 20%, this could of-course be due to a brush that wasn't meant for it. I'd still advice people against using it just yet, but if someone who has seen it working before the fault can take a look and confirm that it's not behaving properly that would be great.
Update 05/09/2012
Billy has offered to fit the brushes if someone orders the brushes. Expressed concern about the off-centering of the armature, which will probably require the motor to be replaced in the future.