Difference between revisions of "Lulzbot Mini"
(don't use Pritt Stick with rigid filament.) |
|||
| (One intermediate revision by one other user not shown) | |||
| Line 14: | Line 14: | ||
|origin=Donation from Lulzbot | |origin=Donation from Lulzbot | ||
|location=3D printer area, Ground floor | |location=3D printer area, Ground floor | ||
| − | |maintainers= | + | |maintainers=tgreer, Welshie |
}} | }} | ||
=== Hull === | === Hull === | ||
| Line 30: | Line 30: | ||
please contact the maintainers if you wish to use a filament that is not available. | please contact the maintainers if you wish to use a filament that is not available. | ||
| − | There is no need to use Pritt Stick, or other adhesive, to get the print to adhere to the bed with rigid filament. Applying excessive Pritt Stick merely cakes the bed in gunk, making the first few layers of your print look messy and lumpy. | + | There is no need to use Pritt Stick, or other adhesive, to get the print to adhere to the bed with rigid filament. Applying excessive Pritt Stick merely cakes the bed in gunk, making the first few layers of your print look messy and lumpy. If you find the bed like this, it can be cleaned off with a warm soapy sponge. |
= Cost = | = Cost = | ||
Revision as of 12:22, 21 January 2019
| Lulzbot 1 (Hull) | |
|---|---|
 | |
| Model | Lulzbot Mini Standard Extruder |
| Sub-category | CNC |
| Status | Check the Tools Status Page |
| Last updated | 21 February 2022 13:37:43 |
| Consumables | XT filament |
| Accessories | Print removal knife |
| Training requirement | yes |
| Training link | https://wiki.london.hackspace.org.uk/view/Lulzbot_Mini_Training |
| ACnode | yes |
| Owner | Hackspace |
| Origin | Donation from Lulzbot |
| Location | 3D printer area, Ground floor |
| Maintainers | tgreer, Welshie |
Hull
Hull is a Lulzbot Mini Standard.
Accessible via http://hull from inside the hackspace network.
Filament
Only use the provided XT filament.
Hull will theoretically print the follow filaments:
- PLA
- ABS
- XT
- Nylon
please contact the maintainers if you wish to use a filament that is not available.
There is no need to use Pritt Stick, or other adhesive, to get the print to adhere to the bed with rigid filament. Applying excessive Pritt Stick merely cakes the bed in gunk, making the first few layers of your print look messy and lumpy. If you find the bed like this, it can be cleaned off with a warm soapy sponge.
Cost
Using the printers costs £1.50/hour of printing + 50p/meter of filament. Octoprint gives you both of these.
Training
Training is required. There is a cost of £5 to be trained (waived if trained on the old printer), payable to the trainer.
Logging
All prints are to be logged via : http://goo.gl/forms/ARNWXexh7zXHSq8p1