Difference between revisions of "Triton Thickness Planer"
(Page Creation) |
(Image Added) |
||
| Line 1: | Line 1: | ||
{{EquipmentInfobox | {{EquipmentInfobox | ||
|name=Thickness Planer (Triton) | |name=Thickness Planer (Triton) | ||
| − | |image= | + | |image=Triton Thickness Planer.jpg |
|model=Unknown | |model=Unknown | ||
|category=Equipment | |category=Equipment | ||
| Line 12: | Line 12: | ||
}} | }} | ||
A thickness planer used to get 2 surfaces of a board parallel and then reduce them to a controlled thickness | A thickness planer used to get 2 surfaces of a board parallel and then reduce them to a controlled thickness | ||
| + | |||
| + | No training requirement, but please seek advice from other woodshop users if you are unfamiliar with its use | ||
Often used in conjunction with the [[Equipment/Tyzack Planer|surface planer]] which makes the initial flat surface on one face of the board | Often used in conjunction with the [[Equipment/Tyzack Planer|surface planer]] which makes the initial flat surface on one face of the board | ||
| Line 19: | Line 21: | ||
Do not use any reclaimed wood (in particular pallet wood) on this machine - even tiny fragments of nails, screws or staples left in the wood will chip the blades | Do not use any reclaimed wood (in particular pallet wood) on this machine - even tiny fragments of nails, screws or staples left in the wood will chip the blades | ||
| − | Do not attempt to plane end grain (e.g. glued up cutting board) in this machine, they are very likely to break and fire | + | Do not attempt to plane end grain (e.g. glued up cutting board) in this machine, they are very likely to break and fire back out of the machine |
Do not attempt to plane short workpieces (less than around 250mm long) - they will be unsupported by the feed rollers during the middle of the cut so will spin and jam inside the machine | Do not attempt to plane short workpieces (less than around 250mm long) - they will be unsupported by the feed rollers during the middle of the cut so will spin and jam inside the machine | ||
Revision as of 19:29, 20 January 2022
| Thickness Planer (Triton) | |
|---|---|
 | |
| Model | Unknown |
| Sub-category | Woodworking |
| Status | Good working order |
| Last updated | 8 August 2022 11:43:58 |
| Training requirement | no |
| ACnode | no |
| Location | Wood shop |
| Maintainers | Woodshop team |
A thickness planer used to get 2 surfaces of a board parallel and then reduce them to a controlled thickness
No training requirement, but please seek advice from other woodshop users if you are unfamiliar with its use
Often used in conjunction with the surface planer which makes the initial flat surface on one face of the board
The mechanism has a tendancy to jam if used without chip extraction, for which the portable portable dust extractor should be used
Do not use any reclaimed wood (in particular pallet wood) on this machine - even tiny fragments of nails, screws or staples left in the wood will chip the blades
Do not attempt to plane end grain (e.g. glued up cutting board) in this machine, they are very likely to break and fire back out of the machine
Do not attempt to plane short workpieces (less than around 250mm long) - they will be unsupported by the feed rollers during the middle of the cut so will spin and jam inside the machine